DTF Heat Press Instructions
Our DTF transfers are printed on STS PET film using certified non-toxic environmentally friendly STS inks.
1. Heat up press to 300f.
2. Position your garment on the press.
3. Position your transfer on the garment in your desired location, verifying that there are no wrinkles under the transfer.
4. Press transfer for 15 seconds.
5. Wait a few seconds for the film to cool.
6. Peel film (if part of the design is not sticking, lay film back down and press for an additional 15 seconds).
7. With a layer of parchment paper or another t-shirt over the exposed design, press again for 15 seconds.
This final press will improve the durability and softness (hand feel) of the print.
If you have any questions, reach out to us at print@aitl.us
We are happy to help!
DTF Wash Instructions
To ensure that your garments continue to look great well into the future, wash inside out in cold/warm water (avoid HOT) and dry on low heat or hang to dry.
You can wash on standard settings, but your prints will last much longer following the suggestions above.